How do you calculate the pitch-circle diameter of a spur gear?
How do you calculate the pitch-circle diameter of a spur gear?
For a spur gear, the reference pitch-circle diameter is d = m × z in metric units, or d = N / DP in inches. Use module m in millimetres, tooth count z or N, and diametral pitch DP in teeth per inch. Do not substitute outside diameter; for profile-shifted or nonstandard gears, verify the drawing and operating center distance.
Use the tooth-size system shown on the drawing
For a metric spur gear, the reference pitch diameter is d = m × z, where m is module in millimetres and z is tooth count. For an inch-system spur gear, d = N / DP, where N is tooth count and DP is diametral pitch in teeth per inch. The result is millimetres in the first formula and inches in the second.
Pitch-circle diameter, or PCD, normally means the reference diameter in this context. It is not the outside, base or root diameter. The PairGears spur-gear pitch guide explains why the reference circle must be identified before a calculation or measurement is accepted.

Check the units with a worked example
Metric example: module 2.5 mm and 32 teeth give d = 2.5 × 32 = 80 mm. Inch example: 48 teeth and 16 DP give d = 48 / 16 = 3.000 in. Keep one pitch system throughout the calculation; do not put millimetres into the DP equation without converting units.
For a standard, unshifted, full-depth external spur gear, outside diameter can support a preliminary screen: da ≈ m(z + 2). That shortcut is conditional. Wear, chamfers, nonstandard addendum and profile shift can make an outside-diameter estimate misleading, so it should not replace the approved drawing or mating-gear data.

Distinguish reference PCD from the operating mesh
Profile shift does not change the basic reference diameter d = m × z, but it changes other tooth dimensions and may be used with a nonstandard operating center distance. In that case, the working pitch diameters of the assembled pair need a system-level calculation; a single gear’s basic PCD is not the complete installation check.
For a replacement part, count the teeth, confirm module or DP, pressure angle and tooth form, and supply the mating gear and center distance. Inspect the relevant datums and tooth geometry rather than accepting an outside-diameter match alone.

Are you looking for a reliable manufacturer of down home textile products?
We can quickly provide customers with market analysis, technical support and customized services.- *Name
- Phone
- *Title
- *Content


